R-Go Tools HandShoe Right Medium - Specificaties

o provide the optimal support for the human hand the patented shape of the HandShoe Mouse has been defined as follows:\n\nSupport is provided for fingers and thumb. The finger support is a curved surface which follows the finger arch of the relaxed finger (Extensor and Flexor muscles in equilibrium). In view of the anatomical shape of the human hand the thumb supporting element lies at a pre-defined lower level relative to the finger supporting part. Both supports, for thumb and fingers, join to provide the hand palm support.\n\nThe hand palm and finger support starts at the wrist and ends at the finger tips and thus follows the full length of the inner contour of the hand. The width of the hand palm and finger support is defined from its highest point up to the base of the mouse. The outer edge of the little finger (Ulnar) side of the mouse is also provided with a supporting contour.\n\nThe heights of these supporting surfaces are defined in accordance with the size of the mouse. The same applies for the length of the body of the mouse, measured along the contour which supports your fingers and hand palm.\nThese measurements vary in accordance with the size of the human hand, measured from the tip of your ring finger to the base of your hand.\n\nFinally, the thumb supporting surface is curved in such a way that its highest point is situated just below the thumb joints (IP- and MP thumb joints) to provide optimal support.\n\nThe HandShoe Mouse is plug and play; no special software drivers for Mac or PC are needed.\nControls consist of 2 buttons at an ergonomic position and a scroll wheel fitted with a switch mechanism.\n\nThe large size HandShoe Mouse has a third mouse button.\nThis mouse button is not programmable; it has the same function as the click function underneath the scroll wheel.